Just understand that you will probably experience quite a bit of frustration getting the 7975 to work properly, but with enough persistence it actually is possible.Configuring a Cisco 7911 IP phone to my Node Phone service.Thanks I am unable to do a „Conference“ over the Cisco 7942 ie Joining 2 calls. Can you confirm if its working with the above load? your tutorial is great, i need it for a fine tune of my already settings because with the new firmware ( i think its above 9 ) you need the USECALLMANAGER instead ip.
apps42.9-3-1ES26cnu42.9-3-1ES26cvm42sip.9-3-1ES26dsp42.9-3-1ES26jar42sip.9-3-1ES26SIP42.9-3-1SR4-1S.loads term42.default.loads term62.default.loads SEP0024C4xml xml if you have not already factory reset your phone it’s time to do! as the phone reboots, you should hold down the # key until the line buttons flash.
I am unable to do a “Conference” over the Cisco 7942 ie Joining 2 calls.
I make a call, press conf, this places the call on hold I dial another call, the other party answers. Can you confirm if its working with the above load? This is one that stumped the heck out of me until I found someone else griping about the same. Symptom: Asterisk sip set debug [ip-of-phone] will report e.g.
Typical ones to ignore are the following: Those are actually “normal”, what you do not want to see is “Unable to Parse file”, that will tell you that it did not like something in your config file.
This can be something like using a host name when it wants an IP address.